Shift Solenoid D Electrical
What it means
The transmission control module (TCM) has found that the shift solenoid D circuit is open, shorted or has out-of-range resistance. The computer stops using the solenoid and usually puts the transmission in limp mode, so some gears are lost until the fault is repaired.
Symptoms4
- Upper gears or some shifts missing, with high engine speed.
- Transmission held in a fixed gear after the code sets.
- A clunk on engagement or on some shifts.
- Check engine light on.
Possible causes6
- Corroded transmission connector, or oil or water inside it.
- Broken or chafed wire in the solenoid D circuit.
- Open or shorted shift solenoid D coil.
- Damaged internal harness inside the transmission.
- Fault in the solenoid power feed or computer ground.
- Fault in the driver circuit inside the computer (less common).
How to diagnose5
- Read all codes, and note any electrical codes for other solenoids such as P0763.
- Inspect the connector and external harness for oil, corrosion or chafing.
- Measure solenoid D coil resistance and compare it with the manufacturer specification.
- Check the circuit with a multimeter for opens or shorts to ground or power.
- Inspect the internal harness and solenoid after removing the pan if the reading at the connector is wrong.
How to fix6
- Clean and dry the connector, and replace its seal or damaged pins.
- Repair the broken or chafed wire.
- Replace shift solenoid D or the solenoid pack based on test results.
- Replace the internal harness if it is damaged.
- Repair the power feed or ground, and replace the computer only after the above is ruled out.
- Clear the codes, then road test through all gears.
Repair cost
In Saudi riyals; the highlighted part is the expected range for this fault.
The cost is low when a connector or external wire is at fault, and rises when the solenoid, internal harness or computer must be replaced.
Prices are rough estimates for common cars at independent workshops and vary with the car and the source of the part.
Prices last updated: September 2026
Frequently asked questions
Is replacing solenoid D alone enough?
If testing proves its coil is bad and the wiring is fine, yes; but on some transmissions the solenoid is not sold separately and the whole solenoid pack is replaced.
Why is top speed reduced with this code?
Limp mode blocks shifts into some upper gears, so engine speed rises and road speed is limited; this is a deliberate protection.
This guide is for information only and does not replace an inspection by a qualified technician. If the fault involves brakes, steering, engine temperature, electrics or refrigerant, do not attempt the repair yourself.
Report a mistake
Spotted something inaccurate? Tell us and we will review and correct it.
Report received — thank you
This is your private tracking link. It shows the status and our reply as soon as it is posted.
The link is saved in this browser only.