8E

Ice Maker Sensor Error

Home Appliance Error Codes Samsung Refrigerators

Severity Low It can wait a little, but get it checked soon.
Can you still use it? Yes, normally
Who can fix it? Needs a technician
Typical repair time 45 minutes – 1.5 hours
Typical cost SAR 100 to 1,000

What it means

This code appears on Samsung refrigerators with a digital display and an ice maker when the ice maker temperature sensor reads open or illogical. Ice making usually stops or becomes irregular, while the fridge and freezer keep cooling normally. The same code can mean something else on other brands, and its meaning may differ between some Samsung series.

Models covered: Samsung refrigerators with a digital display; the code usually flashes on the temperature display. Codes differ between some series.

Symptoms4

  • 8E flashes on the temperature display.
  • The ice maker makes no new cubes, or makes them only now and then.
  • Cubes may come out stuck together or not fully frozen.
  • Fridge and freezer cooling is normal.

Possible causes5

  • Ice or frozen water around the sensor after a water leak in the ice compartment.
  • Loose or corroded connector in the sensor circuit.
  • Failed sensor, which on some models is part of the ice maker assembly.
  • Damaged wire between the ice maker and the control board.
  • Control board fault (rare).

How to diagnose5

  1. Make sure the freezer or ice compartment door closes well and the ice bucket is seated correctly.
  2. Unplug the fridge for a few minutes, then restart it.
  3. Check the user manual for how to switch the ice maker off and on, or test it, on your model.
  4. A technician unplugs the fridge before removing the ice maker, then measures the sensor and compares the reading with the manufacturer table.
  5. The technician checks the connectors and wiring and looks for ice or frozen water around the sensor.

How to fix6

  1. Close the door properly and reseat the ice bucket.
  2. Clear ice buildup around the ice maker with a manual defrost if needed.
  3. Clean or tighten a corroded connector and repair any damaged wire.
  4. Replace the sensor, or the whole ice maker assembly if the sensor is built into it.
  5. Check the control board only if the sensor and wiring are good.
  6. After a day of running, confirm new cubes are made and the code does not return.

Repair cost

In Saudi riyals; the highlighted part is the expected range for this fault.

The cost is low for a new sensor or connector repair, and reaches the high end if the whole ice maker assembly must be replaced.

Prices are rough estimates including the part and the technician’s fee, and vary with brand, model and part source.
Prices last updated: September 2026

Frequently asked questions

Does 8E affect food cooling?

Usually not. The code concerns only the ice maker, and the fridge and freezer keep cooling normally.

Can I use the fridge without the ice maker until the repair?

Yes. You can switch the ice maker off in the settings as your model manual explains, and close its water supply valve if there is one.

Why might the whole ice maker be replaced?

On some models the sensor is built into the ice maker assembly and is not sold separately, so replacing the assembly is the practical fix.

Was this explanation helpful?

Tap the stars to rate; you can change it later.

This guide is for information only and does not replace an inspection by a qualified technician. If the fault involves brakes, steering, engine temperature, electrics or refrigerant, do not attempt the repair yourself.

Report a mistake

Spotted something inaccurate? Tell us and we will review and correct it.

Only if you want an email when we reply.

4 + 4 = ?

Related codes