Injector Circuit Malfunction - Cylinder 6
What it means
This code means the engine computer found an open or short in the fuel injector circuit for cylinder 6, which is common on six-cylinder engines. Cylinder 6 then runs with too little fuel or none at all, causing a misfire and shaking.
Symptoms4
- Check engine light on, possibly with code P0306.
- Mild to moderate engine shaking at idle.
- Poor performance under load or on hills.
- Higher fuel consumption.
Possible causes5
- Corroded or loose cylinder 6 injector connector.
- Open or shorted wire in the cylinder 6 injector harness, especially on a rear bank close to the firewall.
- Damaged coil in the cylinder 6 injector.
- Injector power problem from a fuse or relay.
- Faulty cylinder 6 injector driver inside the engine computer (rare).
How to diagnose6
- Locate cylinder 6 using the service information before testing, because numbering differs between manufacturers.
- Inspect the cylinder 6 injector connector and wiring for corrosion or heat damage.
- Measure the cylinder 6 injector resistance at the connector or at the computer end and compare it with the specification.
- Confirm supply voltage and drive pulses at injector 6 with a noid light or an oscilloscope.
- If it is reachable, swap the cylinder 6 injector with another injector on the same bank and see if the code moves.
- Do not use an ordinary test light on direct-injection or diesel circuits, because they use high voltage.
How to fix6
- Clean or replace the cylinder 6 injector connector.
- Repair the damaged wire in the cylinder 6 injector harness.
- Replace a failed fuse or relay.
- Replace the cylinder 6 injector if it is proven faulty, along with its seals.
- Test or replace the engine computer only after ruling out other causes.
- Clear the codes, then road test and confirm the code does not return.
Repair cost
In Saudi riyals; the highlighted part is the expected range for this fault.
The cost is low for a connector or wire repair and rises for an injector replacement; labor increases when the injector sits on the rear bank under the intake manifold, while a computer failure is rare.
Prices are rough estimates for common cars at independent workshops and vary with the car and the source of the part.
Prices last updated: September 2026
Frequently asked questions
Why is the cylinder 6 injector sometimes hard to reach?
On many V6 engines some injectors sit under the intake manifold or near the firewall, so testing or replacing them takes longer.
Does this code mean the injector is clogged?
No. It is an electrical circuit code; a clogged injector usually shows up as a misfire or lean condition without a circuit code.
Can I drive with this code?
Only a short distance and gently, because a continued misfire in cylinder 6 harms the catalytic converter.
Was this explanation helpful?
Tap the stars to rate; you can change it later.
What was wrong? (optional)
This guide is for information only and does not replace an inspection by a qualified technician. If the fault involves brakes, steering, engine temperature, electrics or refrigerant, do not attempt the repair yourself.
Report a mistake
Spotted something inaccurate? Tell us and we will review and correct it.
Report received — thank you
This is your private tracking link. It shows the status and our reply as soon as it is posted.
The link is saved in this browser only.