Fuel Level Sensor "A" Circuit
What it means
The engine computer has detected a fault in the fuel level sensor circuit inside the tank. This affects the accuracy of the fuel gauge and also stops the computer from running the EVAP test, which needs to know the fuel level.
Symptoms4
- Fuel gauge reads wrong, fluctuates or sticks at one value.
- Check engine light on.
- Low fuel warning comes on at the wrong time or not at all.
- Risk of running out of fuel unexpectedly because of the wrong reading.
Possible causes5
- Worn resistor track in the fuel level sensor or a damaged float arm.
- Corroded or loose connector on top of the tank.
- Open or shorted wiring between the tank and the instrument cluster or computer.
- Poor ground for the sensor.
- Fault in the instrument cluster or the module that reads the sensor (less common).
How to diagnose5
- Compare the fuel level reading on a scan tool with the actual amount in the tank.
- Inspect the connector on top of the tank, often reached through a panel under the rear seat or by lowering the tank.
- Measure the sensor resistance at the connector and compare it with the manufacturer specification for the current fuel level.
- Check the wiring and ground between the sensor and the cluster or computer.
- Check for communication codes or other faults in the instrument cluster.
How to fix5
- Clean or repair the connector.
- Repair damaged wiring or the ground point.
- Replace the fuel level sensor if its resistance is erratic.
- Replace the whole pump module if the sensor is built in and not sold separately.
- Clear the codes and confirm the gauge matches the actual fuel amount.
Repair cost
In Saudi riyals; the highlighted part is the expected range for this fault.
The cost is low for a connector or wiring fault, and rises when the sensor is part of the fuel pump module or the tank must be lowered.
Prices are rough estimates for common cars at independent workshops and vary with the car and the source of the part.
Prices last updated: September 2026
Frequently asked questions
Can I drive with this code?
Yes, but do not rely on the fuel gauge. Track the distance since the last full fill-up so you do not run out of fuel.
Why does the engine computer care about fuel level?
It needs the fuel level to run the EVAP test accurately, so that test stops when the sensor fails.
Was this explanation helpful?
Tap the stars to rate; you can change it later.
What was wrong? (optional)
This guide is for information only and does not replace an inspection by a qualified technician. If the fault involves brakes, steering, engine temperature, electrics or refrigerant, do not attempt the repair yourself.
Report a mistake
Spotted something inaccurate? Tell us and we will review and correct it.
Report received — thank you
This is your private tracking link. It shows the status and our reply as soon as it is posted.
The link is saved in this browser only.