ER FS

Freezer Compartment Sensor Error

Home Appliance Error Codes LG Refrigerators

Severity Medium Do not ignore it; it may get worse and cost more.
Can you still use it? With care until repaired
Who can fix it? Needs a technician
Typical repair time 30 minutes – 1.5 hours
Typical cost SAR 100 to 1,500

What it means

This code appears on LG refrigerators with a digital display and means the main board is reading an impossible value from the temperature sensor (thermistor) in the freezer compartment, usually because the sensor or its connection is open or shorted. The refrigerator may keep cooling on an estimated basis, but the freezer temperature may not be controlled, which affects frozen food; the same code can mean something else on other brands.

Models covered: LG refrigerators with a digital display (e.g. side-by-side, French door and top-freezer models); the code shows as Er plus two letters.

Symptoms4

  • Er FS shows on the refrigerator display.
  • Frozen food is softer than usual, or the freezer is colder than needed.
  • The compressor runs non-stop or at irregular intervals.
  • The freezer temperature setting on the display has little effect.

Possible causes5

  • Loose or corroded sensor connector from moisture and frost.
  • Failed freezer compartment sensor, open or shorted.
  • Broken or pinched sensor wire.
  • Frozen water reaching the sensor area after ice buildup.
  • A fault in the sensor input circuit on the main board.

How to diagnose5

  1. Unplug the refrigerator for a few minutes and plug it back in; if the code returns, the fault is real.
  2. Put a thermometer in the freezer to watch the real temperature until the repair.
  3. Keep the freezer door closed as much as possible and check that its gasket seals.
  4. A technician unplugs the refrigerator before opening any cover, then measures the sensor resistance against the LG temperature-resistance table.
  5. The technician checks the connector and wiring; if they and the sensor are good, the main board is at fault.

How to fix5

  1. Dry, clean and reseat the sensor connector.
  2. Repair a broken or pinched sensor wire.
  3. Replace the freezer compartment sensor with the correct part for the model.
  4. Replace the main board only after the sensor and wiring are confirmed good.
  5. Run the refrigerator and check with a thermometer that the freezer temperature is steady without the code returning.

Repair cost

In Saudi riyals; the highlighted part is the expected range for this fault.

Most cases are solved with a new sensor or a connector repair at low cost; the price rises only if the main board must be replaced.

Prices are rough estimates including the part and the technician’s fee, and vary with brand, model and part source.
Prices last updated: September 2026

Frequently asked questions

Is my frozen food at risk?

It can be if the freezer warms up. Watch it with a thermometer, keep the door closed, and throw away any food that thawed and that you doubt.

What is the difference between Er FS and Er rS?

Er FS is the freezer compartment sensor, while Er rS is the fresh food compartment sensor. The fault is the same kind, just in a different place.

Was this explanation helpful?

Tap the stars to rate; you can change it later.

This guide is for information only and does not replace an inspection by a qualified technician. If the fault involves brakes, steering, engine temperature, electrics or refrigerant, do not attempt the repair yourself.

Report a mistake

Spotted something inaccurate? Tell us and we will review and correct it.

Only if you want an email when we reply.

4 + 4 = ?

Related codes